Add some further jingle and sparkle to your yard this 12 months with a hand-crafted beaded wind chime! I’ll admit that I’m a little bit of a craft provide hoarder and have gathered a large quantity of gorgeous beads through the years however have barely used them. This challenge is the proper excuse to get out my bead provide and make one thing I’ll get pleasure from seeing out my window every single day.
Supplies:
Make It!
Begin by drilling holes in your piece of driftwood (or picket dowel). I used a pen to mark the place I wished the holes to go. I selected to make 5 holes, however you would make as many as you want.
Pour your beads, charms and bells into small bowls or teacups (I sorted mine by coloration). Then minimize a size of nylon beading thread to approx. 22” in size. Tie a bell to at least one finish, leaving just a few inches of extra thread on the finish of the knot. Thread the needle onto the opposite finish of the string.
Start threading beads onto the nylon string. I selected to have every strand be a distinct coloration, to create a rainbow impact. I additionally combined in picket beads and steel charms.
When you’ve completed beading your strand, unthread the needle. Then, ensuring to not lose your beads, thread the needle onto the few inches of string you left on the backside (from knotting the bell). Then insert the needle again up by means of two or three beads to cover the top of the thread. Snip off any extra string and thoroughly set the beaded strand apart and begin the subsequent one.
Proceed to create beaded strands till you’ve gotten one for every gap that you just made within the driftwood.
When you’re finished you possibly can lay the completed strands out and make any changes you may want. I wished my beaded wind chime to hold at totally different lengths so I eliminated just a few beads from some strands and added beads to others till I achieved a glance I preferred.
Subsequent, rigorously decide up the primary strand. Thread the needle and string it by means of the primary gap within the driftwood. Thread a bead onto the highest of the wooden and thoroughly tie a safe knot across the bead. Thread the surplus string again down by means of the driftwood and thru just a few beads, then snip any extra.
Repeat this course of till all beaded strands are secured onto the wooden.
Lastly, make a hanger by wrapping twine round one finish of the wooden, securing with a knot. Then permit some slack for the beaded wind chime to hold from and wrap the string across the different finish of the wooden. Safe with a knot (I additionally coated the top of my string with some kraft glue to carry it down) and also you’re finished! Cling exterior a window the place you possibly can get pleasure from its magnificence and listen to it chime within the wind.
See Extra Craft Tasks You’ll Love:
